Four requirements for power equipment of second-hand gang tool lathes
The power supply equipment is the most important support part of the second-hand gang tool lathe, which can be said to be the heart power source. If the power supply device has a break or malfunction, the second-hand gang tool lathe system will be directly destroyed and cannot be used again. In order to let everyone understand the power The importance of second-hand gang tool lathes. Today, Jiuku Second-hand Equipment will briefly introduce you to the four major requirements of second-hand gang tool lathes for power equipment. I hope it will be helpful to everyone.
The operating data, setting data and machining programs of the second-hand gang tool lathe system are generally stored in RAM memory, just like a computer. After the system is suddenly powered off, some may rely on the backup battery of the power supply. However, if the power failure time passes Long, it may cause data loss and make the system unable to run. At the same time, because the equipment uses a three-phase AC 380V power supply, safety is also an important part of the preliminary work of CNC equipment installation. Based on the above reasons, the power supply used by the lathe has the following requirements:
1. Lathe requirements for compressed air supply system CNC machine tools generally use more pneumatic components, so the workshop should be connected to a clean and dry compressed air supply system network. Its flow and pressure should meet the requirements. The compressed air machine should be installed far away from the CNC The place of the machine tool. According to the layout of the plant and the amount of air consumption, consideration should be given to installing refrigerated air compressors, air filters, air storage tanks, safety valves and other equipment in the compressed air supply system network.
2. The requirements of the lathe for the working environment. Precision CNC equipment generally requires a constant temperature environment. Only under constant temperature conditions can the accuracy and machinability of the machine tool be guaranteed. Generally, lathes have no specific requirements for room temperature, but a lot of practice shows that when the room temperature is too high, CNC The failure rate of the system has greatly increased.
3. The grid voltage fluctuation should be controlled between +10%～-15%, and the power supply voltage should be controlled between +10%～-15%. During the peak electricity consumption period, such as about an hour before going to work or leaving get off work during the day At night, the deviation is often greater, even as high as ±20%, which causes the machine tool to alarm and cannot work normally, causing damage to the machine tool power system.
4. If you need to use other power sources to power certain parts of electrical equipment, these power sources should be taken from the equipment as much as possible to form part of the lathe. For large and complex machinery, including multiple machinery working together, it takes up a lot of space and may require multiple Inductive power supply, which depends on the configuration of the on-site power supply.
The above content is a detailed introduction to the power equipment requirements of second-hand gang tool lathes, and I hope it will be helpful to everyone. If you want to know more about second-hand equipment, you may wish to pay attention to Jiuku second-hand equipment.